Striker ColdShot II Water/Methanol Injection System with 2-Quart reservoir
Striker ColdShot II - 2-Quart Reservoir
Fitment- Universal any turbocharged Gas or Diesel engine
All the power and quality of the ColdShot Water/Methanol System at a substantially reduced cost. The new controller features a 4 push button interface, an external low water LED connection, two 7-segment display LEDs and internal 4 Bar boost sensor. Still the most complete, highest quality, budget priced kit on the market today.
New ColdShot II controller features:
1. 4 Push button switch interface [UP/DN/Mode/Power]
2. External Low Water LED connection
3. 2 (7)-Segment Display LEDs.
4. Internal 4-Bar Boost Sensor
Kit includes the following:
ColdShot II controller with on board 4-Bar boost sensor
One nozzle holder
Three nozzles to choose from
Shurflo water/methanol pump
25 Ft. of Nylon 11 high pressure tubing
Nickel plated brass fittings
Custom wire harness
Mounting hardware
Weatherproof connectors
Simple 5 step set-up onto any vehicle:
1. Install ColdShot II kit to your vehicle using our fully illustrated installation manual.
2. Set start injection boost pressure (boost pressure at which you would like digital progressive control of the water/methanol injection to start).
3. Set full injection boost pressure (boost pressure where maximum injection pressure/quantity is needed).
4. Set injection curve (choose from 4 injection curves; linear, advanced slope, retarded slope and on/off).
5. Drive your vehicle and adjust the settings as needed
